Turnstiles, Flap & Speed Gates: corporate building entrance with controlled access
Access Control Systems

Turnstiles, Flap Barriers and Speed Gates for Controlled Entry

Enforce one person per entry at lobbies, factory gates and event entrances, with lanes that open freely the moment the fire alarm sounds.

Since 2014
Based in Nashik
500+ Clients
Across four states
Survey to AMC
One accountable team
Written and reviewed by the Shruti IT Service engineering team, Nashik. Last updated November 2026.
In short

Turnstiles, flap barriers and speed gates are pedestrian entrance devices that let one person through per valid read. Shruti IT Service supplies and installs tripod turnstiles, optical flap barriers, speed gates and full-height turnstiles, connects them to card or biometric readers, and wires emergency fail-safe opening to the fire alarm so lanes release during an evacuation.

At a glance

Typical timeline
Four to eight weeks, including civil base work, depending on lane count and site readiness.
Key standards
NBC 2016 Part 4 egress principles, IS 732 wiring, and manufacturer IP and safety ratings.
What you receive
Lane layout drawing, installed units, reader integration, fire release test record and operator training.
Best suited for
Corporate lobbies, factory gates, transit style entrances, campuses and stadiums.
Our scope
Barrier supply, base work, power, reader integration, fire interface and commissioning.
Site survey
Peak flow count, lane width, floor condition, weather exposure and nearest emergency exit route.
OVERVIEW

Turnstiles, Flap & Speed Gates Overview

A door controls who may enter. A turnstile controls how many may enter on one read. That second function is what stops tailgating, where one person badges in and three follow. For a lobby with hundreds of daily visitors and a serious audit trail, turnstiles, flap barriers and speed gates turn a reader into a real physical filter.

The right device depends on throughput, appearance and risk. A tripod turnstile is compact and low cost, suited to factory gates and canteens. A flap barrier uses optical sensors and soft flaps for a smoother, faster lobby experience. A speed gate has glass wings, handles higher flow and looks the part in a premium reception. A full-height turnstile is a tall rotating cage for perimeter gates where climbing over must be blocked.

We install pedestrian entrance control across Maharashtra for offices, plants and institutions, and we treat the fire alarm interface as part of the product, not an optional extra. A lane that stays locked during an evacuation is a life safety fault, so release behaviour is designed and tested at the start of the job, not discovered at the end.

We also tell clients when a turnstile is the wrong tool. A low-traffic side entrance with a guard on duty rarely needs one. A door with a reader and a camera may do the job for a fraction of the cost, and we say so after the survey.

Ideal for: Corporate lobbies, factories, transit-style entrances and stadiums.

SCOPE OF WORK

What Our Turnstiles, Flap & Speed Gates Includes

Our scope covers the barrier, the base it sits on, the power and control behind it and the emergency release that must always work.

Tripod turnstiles, flap barriers and speed gates

We supply and install the device that fits your flow and entrance style, with lane widths and accessibility lanes planned. Tip: ask for the throughput in passages per minute under real conditions, and ask whether the figure includes the reader time per person.

Full-height turnstiles for perimeter gates

We install tall stainless or coated steel turnstiles at plant and campus gates, with foundations, drainage and weather protection. Tip: provide a separate vehicle and goods gate, and a guard cabin nearby, since full-height units cannot pass trolleys or large loads.

Integration with biometric and card readers

We connect readers to lane controllers and the access software, with direction logic for entry and exit, anti-passback and passage counting. Tip: test reader placement with a line of real users, because a few centimetres of distance changes read speed.

Emergency fail-safe opening with fire alarm

We wire dry contact release from the fire panel and test each lane with alarm and power loss. Tip: ask for the test record to be signed by your fire consultant, since an inspector may request it later.

Civil base, power and weather protection

We specify and check base plates, conduits, power, earthing and canopies. Tip: agree floor finishing sequence with the civil contractor, since cutting finished tiles after installation is a common and avoidable delay.

THE PROBLEM WE SOLVE

Tailgating, queues and blocked escape routes

Most entrances fail in one of two ways. Either they are open enough that anyone can walk in behind an authorised person, or they are so slow that staff queue at shift change and begin holding the door for one another. Both defeat the purpose. The first is a security gap, the second makes the security staff look like an obstacle.

The third problem is quieter and more serious. Turnstiles installed without thought for evacuation can trap people if power fails or the alarm sounds. Building inspectors and fire officers look at this first. Any pedestrian barrier on an escape route must open to a clear width without a card, and must fail to the open state when power drops, unless a separate escape door is provided beside it.

Mechanical wear is the fourth issue. Tripod arms in factories take daily abuse from bags, trolleys and rain. Without proper bases, sealed mechanisms and regular lubrication, arms loosen and bar settings drift within months. Specifying the right duty class for the real flow matters more than the headline price.

KEY BENEFITS

What You Gain

One person, one entry

The device enforces a single passage per valid read, which ends tailgating at the lobby and gives the access log true headcount for the first time.

Smooth peak flow

Optical flap barriers and speed gates pass a person in under two seconds in normal operation, so shift change queues stay short and staff do not bypass the system.

Reception control

Guards or receptionists see clear green and red indications, alarms for forced passage and a dedicated visitor lane, which lets staff supervise instead of stopping people by hand.

Safe emergency release

Lanes drop arms or open flaps on fire alarm and power loss. Release is tested with the alarm system so evacuation is not slowed by the access control.

Right device per entrance

Tripods for utility gates, flap barriers for lobbies, speed gates for premium reception and full-height units for the perimeter, each chosen for traffic and risk.

Reader and software ready

Lanes accept card, biometric and QR inputs and report passage events to the central software, so access rules and logs stay in one place.

OUR PROCESS

How the Work Is Delivered

Entrance control is a mix of civil, electrical and software work, so our process puts site conditions and evacuation behaviour first.

  1. 1

    Flow study and site survey

    We count or estimate peak arrivals per minute, measure the entrance width, check the floor slab, and note weather exposure, existing guard posts and the nearest emergency exit route.

  2. 2

    Device selection and lane layout

    You receive a lane layout showing device type, lane width, accessible lane for wheelchairs and trolleys, guard position and reader location, with throughput numbers for the chosen devices.

  3. 3

    Civil and electrical preparation

    We specify base plates, cable conduits under the floor, power points and earthing. Floor finishing is usually the client's work, so we agree who does what and when before ordering.

  4. 4

    Supply and installation

    Units are fixed on level bases, aligned for smooth passage and connected to power and control cables. Outdoor units are placed under canopies where possible and fitted with weather protection.

  5. 5

    Reader and software integration

    Readers are mounted at the correct height and distance for each lane, connected to controllers and linked to the access software, with entry and exit direction rules configured.

  6. 6

    Fire alarm interface and testing

    We wire the release signal from the fire alarm panel, then test by triggering a zone alarm and cutting power. Each lane must open to full width, and the result is recorded in the test sheet.

  7. 7

    Handover and AMC

    Operators and guards are trained on bypass keys, alarm reset and emergency procedure. AMC terms agreed per site cover mechanism lubrication, sensor cleaning and release testing.

TECHNOLOGY AND STANDARDS

Tripod, flap, speed gate and full-height: how they differ

Tripod turnstiles use three rotating arms and are the most economical choice. They pass about 20 to 30 people per minute and suit factory gates and canteens, but they are awkward for people with bags or luggage. Flap barriers use infrared sensors to detect passage and retract flaps, passing roughly 30 to 40 people per minute with a smoother feel. Speed gates have glass wings and wider lanes, suited to premium lobbies, and can include wide lanes for wheelchairs.

Full-height turnstiles use a tall rotating cage and are designed for outdoor perimeter gates where climbing over would defeat a waist-high unit. They are usually built from stainless steel or coated steel and need a proper foundation. For outdoor sites, check the protection class, corrosion resistance and monsoon drainage. All types should offer a clear emergency release mode, and each lane needs a bypass lane or swing gate for trolleys, wheelchairs and deliveries.

NBC 2016 Part 4 egress principles

Pedestrian barriers on an exit route must open without a key or card during an emergency, and escape width must be maintained. Final approval of the egress design rests with your fire consultant, and we build to their requirement.

Fail-safe behaviour on power loss

Units used on exit routes should release when power drops. Battery backup is optional, but behaviour in each state, power on, power off and alarm, must be written down and tested.

IS 732 wiring and earthing

Barriers use mains supply and motors. Correct cable size, protective earthing and isolation switches protect users and equipment, especially on outdoor lanes exposed to rain.

Duty class and throughput rating

Manufacturers publish passages per minute and design cycles. We match the duty class to your real flow, since a light duty tripod at a 2,000 person gate wears out in a short time.

IP rating for outdoor lanes

Outdoor units need an adequate ingress protection class, drainage and corrosion resistant finish for monsoon and dust. We also check for sun glare problems that confuse infrared sensors.

WORKED EXAMPLE

Worked example: flap barriers for a 1,200 person office lobby

A corporate office has 1,200 employees. Surveys show 70 percent arrive within a 30 minute window in the morning, about 840 people. That is 28 per minute on average, but real arrivals bunch, so the peak may reach twice that. At about 30 people per minute per lane, a single lane would back up, so we plan four entry lanes and two exit lanes, with one wide lane for visitors and wheelchairs.

We choose optical flap barriers for the main lanes and a wide swing lane beside them under reception supervision. Card readers sit at an angle so people can read without slowing. Visitor badges with a QR code are handled at the wide lane. Lane units connect to the existing access controllers and receive the fire alarm release relay through a dry contact.

At commissioning, we trigger a fire zone alarm and confirm every flap retracts, then cut power and confirm the same. We then run a timed trial with staff in groups to measure queue length and adjust sensor sensitivity so bags and umbrellas do not trigger false alarms.

What the client typically sees
  • Morning queue held within a short, predictable wait
  • Tailgating alarms raised at the guard desk
  • All lanes open on fire alarm and power loss
  • Visitors and wheelchair users served by a separate lane

This is an illustrative scenario built from typical site conditions. Actual quantities, timelines and results depend on your site survey.

SERVICE AREA

Turnstiles, Flap & Speed Gates Across Four States

We are based in Nashik and deliver across Maharashtra, Gujarat, Madhya Pradesh and Rajasthan. Each state has its own utilities, approvals and site conditions, and these are the points that matter most for this service.

Maharashtra

Corporate lobbies in Nashik and the larger cities, factory gates in MIDC estates and campuses are typical. Outdoor tripods and full-height units face strong monsoon rain, so bases need drainage and canopies. Escape width is checked against NBC 2016 Part 4 and the local fire authority.

Gujarat

Plant and port gates in coastal Gujarat expose stainless or coated steel to salt laden air, so material grade and fixings matter more than finish. GIDC estate gates carry heavy shift crowds. Gujarat has its own fire prevention and life safety act, so confirm lane release with the fire authority.

Madhya Pradesh

Factory gates, university campuses and government offices around Indore and Bhopal see hot summers and strong monsoon. Full-height turnstiles suit plant perimeters, with a separate goods gate. Power supply varies, so lanes must fail to open on power loss and be tested that way.

Rajasthan

Stadiums, fairs, temples and industrial gates meet extreme heat and fine dust. Flap barrier optical sensors clog and drift in dust and glare, so we use shaded installation, sealed sensors and cleaning in AMC. Confirm the local fire authority requirement for crowd venues.

INDUSTRIES SERVED

Where This Work Is Most Often Needed

Corporate Offices and IT ParksManufacturing and Industrial PlantsEducation and CampusesSmart City and GovernmentReal Estate and Townships
WHY SHRUTI IT SERVICE

Why Teams Work With Us on This

Fire release is part of the job

We install and test the fire alarm interface ourselves where we also supply the alarm system, so the evacuation behaviour is verified by one team in one visit.

Reader and lane from one source

We integrate biometric, card and visitor systems into the lane, so a failed read can be traced inside one contract, without disputes between barrier and reader suppliers.

Flow based sizing

We size lane counts from your peak arrival data, not from the catalogue, and show the arithmetic so your facilities team can challenge it before approval.

Support planned from Nashik

Teams are mobilised from our Nashik base for installation and commissioning. Mechanism checks, sensor cleaning and release tests are planned by route and site cluster, with AMC agreed per site in the contract.

INSIGHTS AND PROJECTS

Guides and Projects Related to This Service

FAQ

Frequently Asked Questions

01How much does a turnstile or flap barrier cost?

Price depends on device type, lane count, finish and the reader and software behind it. A tripod turnstile costs the least, flap barriers cost more, and speed gates with glass wings cost the most. Civil base work, power and fire interface add to the total. We quote per lane after a survey, with units and installation shown separately.

02What is the difference between a turnstile, a flap barrier and a speed gate?

A turnstile uses rotating arms and is the most economical. A flap barrier uses optical sensors and soft flaps for faster, smoother passage. A speed gate uses glass wings and wide lanes for premium lobbies. The choice depends on peak flow, appearance and how much luggage or equipment people carry through.

03Do turnstiles open during a fire?

They should, and ours are wired to. We connect a fire alarm relay so lanes release to full width on alarm, and units fail to the open state when power drops. We test both conditions at commissioning and record the result. Your fire consultant remains responsible for approving the egress design as a whole.

04Can a turnstile let in wheelchairs, trolleys and deliveries?

Not through the standard lane. Every installation needs an accessible or swing lane for wheelchairs, trolleys and large items, controlled by a reader or by a guard. We plan this lane at design stage and position it near reception, so it is supervised and not a way round the system.

05Can turnstiles be used outdoors in monsoon conditions?

Yes, with the right units and installation. Choose outdoor rated units with adequate ingress protection, stainless or coated steel, proper drainage in the base and a canopy where possible. Mechanisms still need regular cleaning and lubrication in dust and humidity, which we cover in AMC.

06How many people per minute can a lane handle?

A tripod turnstile typically passes 20 to 30 people per minute, and an optical flap barrier or speed gate around 30 to 40 per minute. The figure drops if the reader is slow or people stop to search for cards. We size lane counts using your peak arrival data and add margin for real behaviour.

LET'S BUILD TOGETHER

Ready to Discuss Turnstiles, Flap & Speed Gates?

Tell us about your site, timeline and any tender documents. Our Nashik team will respond with a survey plan and a clear scope.

+91 96070 53335
Call Now